AR15barrels wrote:
I have machined a few FN actions for CDI bottom metel.
It is a very small amount of machining that is necessary.

I think he's concerned about voiding the warranty....... Oh wait, we reload which probably already voids everything.....

That's the only reason I can think of to consider the FN-TBM.

I found FN kit for $366, and bought it, extra mags are $45, and the kit comes with one 5 and 10 rounders, so I should be covered for now. Eventually I will have another rifle build in .260 or 6.5 CM, most likely REM in a chassis.
Meanwhile back to training, more loading and more shooting! :-)

Do you know max COAL that will fit those mags?

COAL is 2.900 with this mags, and I haven't found bad review on this kit yet. Should get everything next week!

Hey guys. I got reports from some people that Angeles has some new steel at the 300 yard line. Some kind of swingers and a KYL rack. Then I asked what color they were. They are yellow. Sounds like the club steel to me. Anybody?

Sounds like it never got picked up! I'll be there in the AM. I will check if its the clubs.

autoessentials wrote:Hey guys. I got reports from some people that Angeles has some new steel at the 300 yard line. Some kind of swingers and a KYL rack. Then I asked what color they were. They are yellow. Sounds like the club steel to me. Anybody?

I shot this morning and that is the Clubs steel KYL rack, Little man Rack also looks like an IPSC at 600 yards. They are now painted black.

Painted black now you say Henry? Hmmm, I wonder if that means that Angeles is trying to claim them.

autoessentials wrote:Painted black now you say Henry? Hmmm, I wonder if that means that Angeles is trying to claim them.

Nah.
The guys just go and paint all the targets at closing, regardless of who's steel it is.
They have done that before when we left it up.
I need to clear the heater out of my truck tomorrow and go put the steel away tomorrow night.
Who is free to help?

I would but I'm in TX.

What time?