Hey all, does anyone have the exact distances for the steel targets at Angeles? The RO's confirmed what my dope is telling me, that they're a bit off from the set 100 yard increments, was hoping to get some better numbers. Thanks.

_________________
Guy Fieri wears Gatorz

Exact numbers? I'm sure it would depend on exactly where you are on the firing line

_________________
"Democracy is two wolves and a lamb deciding what to have for dinner.
Liberty is a well armed lamb with a SAC Alpha 11 protesting that decision." Unknown 2017

Perpendicular to the firing line then, at least a better idea than the nominal distances they give. I'm trying to back-track MV for a couple loads without having to chrono them.

I figure at least one person knows their MV and dope on each of the targets with a given set of environmental conditions and has figured out what the actual distances are.

_________________
Guy Fieri wears Gatorz

The smallest square flapper at 500Y is pretty bang on from the left side of the line. It's right at 1-1.25MOA so it's your best bet for confirming DOPE.

_________________
"Gentlemen you can't fight in here this is the war room!"

_________________
God shoots a Remington 700, drives a Chevy Truck and carries a Glock 19.
I don't do any of those things.

Gotcha, I didn't really think about it much but I guess the angles are significant if you're sweeping across the line. I did come across a thread on calguns discussing DA where a few had mentioned they had independently ranged them and they were within +/- 5 yards of the nominal distances, so if someone comes along looking for this answer later, there you have it. Time for some trigonometry, and I guess allocating the funds for a RF.

Also it was an SPR whose brake you helped me time a while back Randall, so thanks again for that.

_________________
Guy Fieri wears Gatorz

Well the distances are going to vary slightly depending on where you are on the line. If you laze from the ground (with a steady spot to set the rangefinder on) the corrected value may differ than if you laze from the bench.

I was there today and from about middle of the line to the small hanger on the 600 line I lazed it as 608 with corrections for angle to 590. Nailed it on the first shot and confirmed hard dope at all distances up and down the line using these corrected values.

Rifle was dialed in and center punched 1/2 inch dots at 100. Why can't I do that when it counts?!

_________________
In the face of a crisis, a failure to act is the first act of failure.
There are no stupid questions, just stupid people asking questions.
Sweat saves blood, blood saves lives, but brains saves both.

_________________
Guy Fieri wears Gatorz